BGP protocol between RIPng and RIPv2, how to do it?

Hello,
I am having a bit straugling about one example.
I want to make 2 networks, 2 autonomic system, one with IPv6(and RIPng protocol) and second with IPv4(and RIPv2 protocol), and all of that combine with bgp.

Things that I don't know is how to bind that 2 networks, must I all routers configure to bgp, or only 2 (1 from IPv6, and 1 from IPv4)?

Find more posts tagged with

Free for TechExams community: Cybersecurity salary guide

Compare cert salaries and plan your next career move

Button

Comments

xnx

The border / edge router of each AS will have to have BGP running obviously, you can can RIP / EIGRP / OSPF on the interior routers which will connect to the border router

tomislav91

Thanks for reply, but I don't understand, how to make that autonomic systems? Only give a address or what? How to do it in packet tracer?
And, about bgp, if I understand, only 2 router i configure for bgp(1 from 1st AS and 1 from 2nd AS)?

I maked one network with RIPng protocol, here is the link

http://speedy.sh/dd8Fw/zadatak.pkt

And how to make this AS?
And when I add in this project some network with IPv4 and RIPv2, how to bind them wth bgp..
That is what not understand...

fredrikjj

How will your networks communicate when one is running IPv4 and the other IPv6?

tomislav91

I want to make 2 AS, 1st will be with IPv6, and 2nd with IPv4 and bind with bgp. Is that possible? I make(in my earlier post)one IPv6..But how to make AS on that network, and just add IPv4?

I done the dual stack network, but not assigne ASes

http://speedy.sh/zzd7q/CNA-04-006-sol.pkt

Can I put bgp here? In this network??