can I do bgp in packet tracer if I am using IPv6?

tomislav91

I would have liked to use loopback addresses instead of physical interface addresses because I am using IPv6 addressing, but the commands to allow this are not available (update-source and ebgp-multihop).
What to do?
I can't write neighbor IPv6 address remote_as number because I can only use IPv4 address, because I wanted to use loopback addresses, but there is not options for that, like I wrote in previous paragraph.

What to do???

Jon_Cisco

Packet tracer is a simulation software with limited functionality. You will find a lot of features not available in it.
Try using GNS3 it does software emulation using the actual IOS.