ipv6 enabled on each interface?

john_samson

Hi Friends
Should I enable ipv6 on each interface with this command "ipv6 unicast-routing" before I enable RIP or declaring once in the Configuration mode is enough?

saraanand

It's a global command.

R2(config)#ipv6 unicast-routing

VinnyCisco

^^^^^^ What she said..... That command turns it on globally.

Then on your ipv6 interfaces, you set the specific routing protocol.

saraanand

^ Thank you

john_samson

Thanks to all specially Vinny for just answering what I was looking for