Question on assigning a number to FXS port

JeanM

Hi,

I have 2620xm with voice-2v and vic-2fxs card configured with dial-peer pointing to 2811 router (along with 3550 switch) and can dial from the analog phone out to the 7940/7960 phones on the 2811 side . I have also configured the caller id name/number on the fxs 1/1/1 port and it shows on the 79xx side.

What is required to make the calls from the 2811 (CME_TX 192.168.1.199) side to the FXS number on the 2620xm 192.168.1.222 router?

This is what shows when I view the call FROM the Analog phone to the VoIP phone.

CME_TX#sh voip rtp connections detail
VoIP RTP active connections :
No. CallId dstCallId LocalRTP RmtRTP LocalIP RemoteIP
1 156 157 18320 16720 192.168.1.199 192.168.1.222
callId 156 (dir=1): called=808 calling=6600 redirect=
dest callId 157: called=808 calling=6600 redirect=
1 context 48145CBC xmitFunc 40C0660C
Found 1 active RTP connections


CME_TX#

Here are dial peers on the VoIP router

dial-peer voice 2001 voip
description *** to CALL CA ***
destination-pattern 55..
session target ipv4:192.168.1.200
dtmf-relay h245-alphanumeric
!
dial-peer voice 3001 voip
description *** to CALL CA 2 ***
destination-pattern 77..
session target ipv4:192.168.1.200
dtmf-relay h245-alphanumeric
!
dial-peer voice 4001 voip
description *** TO CALL ANALOG ROUTER ***
destination-pattern 66..
session target ipv4:192.168.1.222
dtmf-relay h245-alphanumeric



ephone-dn 1
number 808
label Norms phone
name Norm
!
!
ephone 1
mac-address 0014.F243.EF4B
speed-dial 1 2222 label "Norm"
button 1:2
!



And here are the dial peers on the 2620xm router with the FXS card connected to analog phone.

!
dial-peer voice 4002 voip
description *** TO DIAL TEXAS ***
destination-pattern 11..
session target ipv4:192.168.1.199
dtmf-relay h245-alphanumeric
!
dial-peer voice 4003 voip
description *** TO DIAL TEXAS 2 ***
destination-pattern 80.
session target ipv4:192.168.1.199
dtmf-relay h245-alphanumeric
!
dial-peer voice 4004 voip
description *** TO DIAL CA ***
destination-pattern 55..
session target ipv4:192.168.1.200
dtmf-relay h245-alphanumeric


ephone-dn 1
number 6600
!
!
ephone 1
description TEST


Issue - when dialing from the texas side (192.168.1.199) to 6600 number I am getting a busy signal (not fast busy). Dialing the other way around works fine.

JeanM

Okay, so I think I was missing this on the FXS router, is this the right way?

dial-peer voice 11 pots
description incoming calls to ANALOG
destination-pattern 66..
port 1/1/1
!