Removing BRI sub interfaces

cisco_troublecisco_trouble Inactive Imported Users Posts: 78 ■■□□□□□□□□
in CCNP
Hey All

Hope you enjoyed your festive season....but back to toil and trouble. I have 1700 router, i would like to know if i added a bri1/0.1 interface, how can i remove it from the configs without reloading the configs?

thanx
"To strive, to seek, to find, and not to yield."
· Share on FacebookShare on Twitter

Comments

  • keenonkeenon Member Posts: 1,922 ■■■■□□□□□□
    you should be able to remove it in global config mode

    no int bri1/0.1

    it may give a message about "some config may return if this interface is reactivated".
    Become the stainless steel sharp knife in a drawer full of rusty spoons
    · Share on FacebookShare on Twitter
  • cisco_troublecisco_trouble Inactive Imported Users Posts: 78 ■■□□□□□□□□
    Hey thanx, will check it out later today. Oh yes, congrats on u passing the BCMSN! I'm busy studying for it. Hope i'll be able to leech from your knowledge for time to time.

    Keep cool.
    "To strive, to seek, to find, and not to yield."
    · Share on FacebookShare on Twitter
  • darkuserdarkuser Member Posts: 620 ■■■□□□□□□□
    generally when you remove a subinterface it will be removed , but will show up with a status of "deleted"
    it will not be truly gone until you reload the router.
    rm -rf /
    · Share on FacebookShare on Twitter
  • cisco_troublecisco_trouble Inactive Imported Users Posts: 78 ■■□□□□□□□□
    "Don't mean your head is shaped like a bullet, you a BIG SHOT!"

    From MArtin, in Martin...
    :P
    "To strive, to seek, to find, and not to yield."
    · Share on FacebookShare on Twitter
Sign In or Register to comment.