Voice introduction

Hi all, which material would you suggest to someone without any voice experience to read in order to successfully install, configure and maintain/troubleshoot a Cisco voice solution.

Find more posts tagged with

Free for TechExams community: Cybersecurity salary guide

Compare cert salaries and plan your next career move

Button

Comments

negru_tudor

Hi there. Try these:

- http://www.amazon.com/CCNA-Voice-640-461-Official-Guide/dp/1587204177
- CBT Nuggets: Jeremy Cioara's CCNA Voice nugget series (Cisco VoIP CCNA Voice ICOMM 640-461 Video Training Online | CBT Nuggets)

This and a bit of hands-on with the Kit and you're good to go.

If you're wondering about what kit to use, try this for starters:

- 1 x 2801 Router with a voice-enabled IOS
- 1 x PVDM2-8 or PVDM2-16 (these are DSP resources for Media termination - POTS ports -, conferencing, transcoding etc)
- 1 x VIC2-2FXS for some good old analogue phones
- 2 x Cisco 7940 or 7960 IP phones
- 1 x 3550 Switch for PoE and QoS
- VMware to virtualize CUCM, Unity and CUPS

atorven

Thanks mate

negru_tudor

atorven wrote: »

Thanks mate

You're most welcome. You can also make very good use of GNS3 for a lot of the CME/CUBE stuff. The above will get your taste buds wet on CUCM, CME, Voice Gateways etc
If you want to take it to the next level (or certify) then you have another 5 exams for the CCNP Voice track.
Good luck on your journey!