unable to ping router
hi i have 1 issue in Basic MPLS scenario that i pit for you please help me i config all router completely but there is 1 problem thateven i type:show ip route on any CE router it show all route from all protocols and ospf area but even i ping other CE i cant get any replyi wondered ! what's the problem?for example CE router(MY_IST)can get all route from MY_IZM but cant ping thati put image and gns3 fileDOWNLODA link 1:http://s000.tinyupload.com/?file_id=07163790217374781416link 2 :http://www.freeuploadsite.com/do.php?id=67589
Comments
-
networker050184
Mod Posts: 11,962 Mod
Is there a route back on the other side?An expert is a man who has made all the mistakes which can be made. -
klez0011
Member Posts: 48 ■■□□□□□□□□
thank you for your replynetworker050184 wrote: »Is there a route back on the other side?
what you mean by route back? -
jdballinger
Member Posts: 252
Check the route table on the destination router, make sure it has a route back to the source router. -
klez0011
Member Posts: 48 ■■□□□□□□□□
jdballinger wrote: »Check the route table on the destination router, make sure it has a route back to the source router.
yes i cheched it,it has all route that other CE router has
please see below picture
-
_Gonzalo_
Member Posts: 113
I´d advise basic trobleshooting first...
You are trying to ping MY_IST from MY_IZM. Have you tried traceroute? Have you tried pinging to closer locations? ie. PE2_AS1
With the information you show it is not possible to know where the fault is... First find the device that is not functioning properly and then check it. -
kornus
Member Posts: 12 ■□□□□□□□□□
HI,
Can you show us output from "sh interfaces" command on both ends?
Have you fixed this connection? What was wrong? -
Heero
Member Posts: 486
yes i cheched it,it has all route that other CE router has
please see below picture
You aren't considering the SOURCE address on the echo-request (ping) packet.
