add static route in cisco 2950 switch

Hello,

1. How can I add a static route in cisco 2950 series switch? I added static route in cisco3550 series switch using "ip route..." command. but i could not add static route in 2950. anybody can help me to add this?

2. And can i perform inter vlan routing using 3550 without an external router? i have created two vlan and configure ip per vlan, now what to do...??

suggest plz......

Thanks.

Find more posts tagged with

Save $250 on 2025 certification boot camps from Infosec!

Book now with code EOY2025

Button

Comments

netstat

a 2950 works at layer 2 only. No form of routing can be done, therefore no static routes. 3550 on the other hand is a more advanced switch which supports layer 2 to 4.

(someone correct me if i'm worng

)

http://www.cisco.com/en/US/tech/tk389/tk815/technologies_configuration_example09186a008015f17a.shtml

keenon

the "G" series or enterprise is capable of routing

check the version number

Arturasj

keenon wrote:

the "G" series or enterprise is capable of routing

check the version number

Can you post some links about it.

keenon

http://www.cisco.com/en/US/products/hw/switches/ps628/ps4556/index.html

http://www.cisco.com/en/US/products/hw/switches/ps672/products_tech_note09186a0080093f8f.shtml

heres a start but i will have to locate the rest of the info for you..

darkuser

as stated it is a layer 2 switch.
you can set the default gateway for the management interface,
which should get you where you need to go.