Categories
Welcome Center
Education & Development
Discussions
Certification Preparation
Recent Posts
Groups
Free Resources
Ebooks
Free Workshops
Trending Certifications Infographic
Infosec Training
IT & Security Training
Live Boot Camps
Security Awareness Training
About Infosec Institute
Home
Certification Preparation
Cisco
CCST & CCNA (Entry-level & Associate)
CCNA Monday
nmilot
Taking the CCNA on Monday, just want to get a couple things straight. I've seem some similar questions posted recently, but can't seem to find them now.
1) I should assume subnet-zero cannot be used, correct?
2) The sims..... if you enter an invalid command, will it just accept it and end up marking it wrong, or will it actually tell you invalid command, similar to an actual router or switch.
I've really got to nail down configuring ISDN and frame relay. Anyone run into any sims where you actually have to do this?
Thanks
Find more posts tagged with
Save $250 on 2025 certification boot camps from Infosec!
Book now with code EOY2025
Button
Comments
Webmaster
1. The question will indicate in some way (sometimes explicitely)whether you can use it or not.
2. The router sims are fairly smart. It won't accept commands with an incorrect syntax just like a real router does.
Read the following topics and the links in it for more information:
www.techexams.net/forums/viewtopic.php?t=7268
3. Discussing the content of sims is not allowed. Just focus on the 'Configure' topics listed in the exam objectives.
Good luck on Monday!
mwill
"1) I should assume subnet-zero cannot be used, correct?"
--Incorrect- If subnet-zero will be used the question will phrase it so. "Subnet-Zero is supported" or something in that regards. I did have questions were subnet-zero was used.
"2) The sims..... if you enter an invalid command, will it just accept it and end up marking it wrong, or will it actually tell you invalid command, similar to an actual router or switch."
--If you configure the router or switch incorrectly its just like a real switch, if its a vaild command it will accept it. But if you did it wrong, ofcourse the sim wont work and if you dont correct it before you contiune you will get the sim wrong.
Hope this answers your questions!
EricO
Be prepared to look at configuration examples for both frame relay and ISDN to diagnose problems.
nmilot
Thanks for the feedback. The exam ended up being cancelled today due to yesterday's snowstorm. I need to reschedule tomorrow.
Ten9t6
Good luck and let us know how it goes...
Quick Links
All Categories
Recent Posts
Activity
Unanswered
Groups
Best Of
INFOSEC Boot Camps
$250
OFF
Use code
EOY2025
to receive $250 off your 2025 certification boot camp!
BROWSE BOOT CAMPS