plz help in access list

in CCNA & CCENT
i typed the following command in the boson netsim v6.00 :
router(config)#access-list 100 deny tcp any host 200.200.200.2 eq telnet
and after pressing enter ....%incomlete command
y this happened ?.... is the command correct ?
plz help me .. am going to have the ccna exam tommorow .....
router(config)#access-list 100 deny tcp any host 200.200.200.2 eq telnet
and after pressing enter ....%incomlete command
y this happened ?.... is the command correct ?
plz help me .. am going to have the ccna exam tommorow .....
Comments
access-list 100 deny tcp any host 200.200.200.2 eq 23
but its also alerts with >>> invalid input detected ....
so do u think its a problem of the sim itself ??? or wot ??
I also typed the command into a sim'ed router in NetSim 5.xx and it accepted it and showed up fine in a show access-list command. It's happened where NetSim freaks out and stops accepting commands for some reason. I used to usually just close out and reload my configs -- but that got old after a while -- so I bought hardware.
i just want to know one more thing ... will there be questions about the timers in the ccna exam and if there will be should i know all of them(the updates , the holddown , ...) ?
For the proper way to get some info -- look at TechGirl's last topic (Post subject: Before the test, in the testing center) where timers just happened to come up in the discussion. I had no problem offering up a timer tidbit there, but I had to think long and hard about wether the NDA covered the pre-test questions.... and I decided no on that.... someone correct me if I'm wrong.