Syslog for ccent ?
satishtech
Member Posts: 243
in CCNA & CCENT
Do I need to know the commands for syslog configuration for the ccent ?
I did not see syslog mentioned in the blueprint,though
saw the commands below in the lammle book.
Router(config)#logging host 193.10.40.1
Router(config)#service timestamps log datetime msec
I did not see syslog mentioned in the blueprint,though
saw the commands below in the lammle book.
Router(config)#logging host 193.10.40.1
Router(config)#service timestamps log datetime msec
Comments
-
NightEye00
Member Posts: 21 ■□□□□□□□□□
Hi,
if I'm right, syslog configuration isn't part of ICND1, only ICND2. -
stunnedsoup
Member Posts: 120
Yea, I believe Syslog is listed in item 3.2 of the 200-101 Topics --> Found here.
I do not recall reviewing it for the ICND1. If it was mentioned then I didn't see it or I just forgot about it.Cisco: CCENT COLOR=#ff0000]✔[/COLOR CCNA COLOR=#ff0000]✔[/COLOR || MCSE: 70-410 COLOR=#ff0000]✔[/COLOR 70-411 [ ] 74-409 COLOR=#ff0000]✔[/COLOR 70-534 [ ] || VMWare: VCP [ ] -
Hondabuff
Member Posts: 667 ■■■□□□□□□□
You need to know it for production though.I use an internal NTP server and set everything to EST -5 0.
!
service timestamps log datetime localtime show-timezone year
logging buffered 16000
logging host { IP of Syslogserver}
logging source-interface {Interface that LAN IP is on}
!“The problem with quotes on the Internet is that you can’t always be sure of their authenticity.” ~Abraham Lincoln -
pinkiaiii
Member Posts: 216
there is topic on configuring clocks on routers to synchronize correct time-most likely for when getting to part of syslogs and being able to get right timing from log events,but thats only topic of one page there was to it,so its correct that it would be covered in semester 3-4 or after ccent.