Cisco 891-K9 won't pass bootstrap ...no rommon access, no command line access
Bart222
Registered Users Posts: 1 ■□□□□□□□□□
in CCNA & CCENT
Hello Guys
I'm having an issue with my 891k9, after powering up, all I got is 3 lines of a bootstrap version, and no access to rommon mode at all. I'm not able to type any command, tryied different consols, ctrl+break, reset button, nothing works, it won't boot from usb neither, fan is working on highs speed, and all 8 Fe leds are on ( not blinking) just on. Flash and RAM is integrated on board, so can not take it off, AC/DC adapter works fine, and the battery is OK, any ideas what could I do or try ?
Best regards
Bart
I'm having an issue with my 891k9, after powering up, all I got is 3 lines of a bootstrap version, and no access to rommon mode at all. I'm not able to type any command, tryied different consols, ctrl+break, reset button, nothing works, it won't boot from usb neither, fan is working on highs speed, and all 8 Fe leds are on ( not blinking) just on. Flash and RAM is integrated on board, so can not take it off, AC/DC adapter works fine, and the battery is OK, any ideas what could I do or try ?
Best regards
Bart