Hi everyone,
I am here stuck with a new 2960s that won't boot, I don't know what I did to mess the config so badly, but the switch just won't boot up !
It loads the image then hangs right here:
File "flash:/c2960s...." uncompressed and installed, entry point: 0x3000
executing...
then all the lights on the switch goes dark and stays where it is !
What I did:
* Formattted flash:
* Change IOS to 15.0(2)SE6
* Re-formatted flash:
* Change IOS to 15.0(2)SE9
* Re-re-formatted flash:
* Restore the original one
Always hangs in the same point ! "
entry point: ex3000 executing ..."
Any help would much appreciated !
Thanks !
