Configuring a Frame Relay network lab (getting error)

oucatfish

STEP 6. Configure DLCI mappings

Now we need to configure the DLCI mappings for each interface by using the frame-relay route command. The format for this command is:

frame-switch(config-if)#frame-relay route <input dlci> interface <output interface> <output dlci>

just would like to know if this is correct. i get to this point and type this in and i get a invalid input detected at ect ect..

thank you

mikej412

oucatfish wrote:

frame-switch(config-if)#frame-relay route <input dlci> interface <output interface> <output dlci>

Looks correct -- matches the config from one of my working frame switches

frame-relay switching
!
interface Serial0
 no ip address
 no ip directed-broadcast
 encapsulation frame-relay
 clockrate 64000
 frame-relay lmi-type ansi
 frame-relay intf-type dce
 frame-relay route 102 interface Serial1 201
 frame-relay route 103 interface Serial2 301