Options

Ripv2 No Auto-Summary Command in Router Configuration mode

DaughterofrnbsoulDaughterofrnbsoul Member Posts: 29 ■□□□□□□□□□
in CCNA & CCENT
I'm using packet tracer for my labs, and have issued the No Auto-Summary Command, however I do not see the "No Auto Summary command in the running-configuration, is that an issue with packet tracer ? Does that command show up on "Real Equipment when I do a Show run. :)
· Share on FacebookShare on Twitter

Comments

  • Options
    WastedHatWastedHat Member Posts: 132 ■■■□□□□□□□
    I tried it on packet tracer and my physical router and it shows up in the running config on both. Packet Tracer is v7.0 and I used an 1841 router with IOS 12.4
    · Share on FacebookShare on Twitter
  • Options
    DaughterofrnbsoulDaughterofrnbsoul Member Posts: 29 ■□□□□□□□□□
    hey thanks apparently it's with an older version of packet tracer I was using. I just now upgraded to the new 7.0 and I now see it thanks :O!, I had no idea packet tracer had a newer version out. I guess I was later for the party haha :)
    · Share on FacebookShare on Twitter
Sign In or Register to comment.