a little detail...

the_return_of_the_Ring

the_return_of_the_Ring Member Posts: 119

May 2006 in CCNA & CCENT

I read on Jeremy Cioara's "ccna exam prep" that configuring a switch port to full duplex is as "(config-if)#full-duplex". But in a practice question, I saw the correct answear is "(config-if)#duplex full". Is it because of different switch model or one of them was wrong?

0 ·

Comments

Humper Member Posts: 647

May 2006

I happen to believe it's different IOS's...my 2912 uses full-duplex but I have seen newer switches use duplex full

EDIT:

My switches are running 12.0(5) I believe, if that makes any difference to you...

Now working full time!
0 · Share on Facebook Share on Twitter
xwesleyxwillisx Member Posts: 158

May 2006

I have a 2940 with IOS 12.1. The syntax for that IOS is duplex full.

0 · Share on Facebook Share on Twitter
lwwarner Member Posts: 147 ■■■□□□□□□□

May 2006

According to Cisco, the duplex {auto|full|half} syntax was intoduced in version 12.0(5.2)WC(1).

Bill | Network Professional Association | ETA International
0 · Share on Facebook Share on Twitter
hectorjhrdz Member Posts: 127

May 2006

both are correct...

it depends of IOS ver.

0 · Share on Facebook Share on Twitter

or Register to comment.