Sorry to flood post but in relation to my previous question about the IOS I've just noticed the following error during the router start up sequence:
Bridging software.
X.25 software, Version 3.0.0.
1 Ethernet/IEEE 802.3 interface(s)
1 Serial network interface(s)
32K bytes of non-volatile configuration memory.
16384K bytes of processor board System flash (Read/Write)
transport input none
^
% Invalid input detected at '^' marker.
Doing a show run revealed no sign of this command applied in the config. I'm sure its harmless but I'd like to know if I can correct it!
Any ideas?