keep getting this message when installing a PRI interface?

aueddonline

Unexpected exception to CPUvector 1100, PC = 0
-Traceback= 0 8049283C 804922DC 8049268C 8049381C

r_durant

What device are you installing the module into? IOS version?

Netstudent

also how much memory is in ithe router? Could be an IOS bug.

At any rate, you may want to consider opening a TAC case to decode that traceback if you can.

dtlokee

Are you installing it with the router powered on?

aueddonline

i'm trying to install a FE-2Ce1-B/U here's the show ver, opening a TAC case??????

no haven't got the power on didn't feel like dying today


IOS (tm) C2600 Software (C2600-IO3-M), Version 12.3(3), RELEASE SOFTWARE (fc2)
Copyright (c) 1986-2003 by cisco Systems, Inc.
Compiled Tue 19-Aug-03 16:32 by dchih
Image text-base: 0x80008098, data-base: 0x80D11A24

ROM: System Bootstrap, Version 11.3(2)XA4, RELEASE SOFTWARE (fc1)

r2-server-end uptime is 5 hours, 23 minutes
System returned to ROM by power-on
System image file is "flash:c2600-io3-mz.123-3.bin"

cisco 2610 (MPC860) processor (revision 0x203) with 28672K/4096K bytes of memory.
Processor board ID JAD05400A5W (3100123249)
M860 processor: part number 0, mask 49
Bridging software.
X.25 software, Version 3.0.0.
1 Ethernet/IEEE 802.3 interface(s)
1 Serial network interface(s)
32K bytes of non-volatile configuration memory.
8192K bytes of processor board System flash (Read/Write)

Configuration register is 0x2102

dtlokee

I don't think that network module works in a 2600, I've only ever used them in a 3600's. The other thought is your router only has 32mb of ram and the additional packet buffers may be running it out of ram, but the error code does not seem to indicate that.

aueddonline

that's a shame I was hoping to use it over the next week, I might look out for a 3600, should it have IOS 12.4?