Frame Relay Help

BradGman

Hey Guys,

I was wondering if I could get your help setting up my fictitious network here to use Frame-Relay.

I went through the Frame-Relay tutorial step by step and something seems to be goofing up. All the endpoint routers get the frame-relay map from the main frame-relay switch but are unable to communicate with any of the other points.

http://ainove.com/docs/FrameRelaySetup.pdf

The pdf above is a global layout of the way the network is setup. The only thing "wrong" in it is the IP address on the frame-relay switch, as there is no ip address set for that router per tutorials instructions.

The network is not setup past the cables need for frame-relay. Basically ignore the switches and servers for now.

Equipment:

Frame-Relay Switch: Cisco 2640
Endpoints: 2x Cisco 2610 1x Cisco 2520

Any help would be GREAT!!

Thanks again.

networker050184

No way to help with out your configuration....

mikej412

BradGman wrote:

The only thing "wrong" in it is the IP address on the frame-relay switch, as there is no ip address set for that router per tutorials instructions.

That "wrong address" is probably the network address you should use for the frame-relay connections.

Do you have an actual question or configurations you've done that you want to ask about?

This looks like a simple full mesh configuration with a shared subnet.

dgbarr

is it because you don't have anything that emulates bri ?

Darthn3ss

dgbarr wrote:

is it because you don't have anything that emulates bri ?

ISDN != Frame relay..

phantasm

Darthn3ss wrote:

dgbarr wrote:

is it because you don't have anything that emulates bri ?

ISDN != Frame relay..

That's what I was thinking...