Cable to Connect Routers with T1 Wics

Sorry if this is already been posted a bunch of times, i have searched for a half an hour but couldnt find it. I though i posted something about it myself but apparently not.
Anyhow, I need to create a cable to connect two routers with T1 Wics. What is teh configuration of this cable??

Find more posts tagged with

Free for TechExams community: Cybersecurity salary guide

Compare cert salaries and plan your next career move

Button

Comments

Netstudent

pairs 1 and 2 get crossed over to 4 and 5...vice versa

1. wo

b
2. o

wb
3. wg

not used
4. b

wo
5. wb

o
6. g

not used
7. wbr

not used
8. br

not used

phreak

Yep. ---^

I keep a stash of T crossovers in my cable box at work.

Be sure to set one to clock source internal so you get the full effect of the simulation. Normally the phone company provides line clock and the router draws clock from the plant but on the bench/in the lab you'll have to simulate this.

lex0429

even a picture. talk about service...lol
thanks

yukky

Yeah, that is a nice diagram. Does anyone on this forum sell them? I don't need any right now, but perhaps in the future.

I'm not ready to invest in the equipment to start making my own wires, but maybe I should? Theres just so much choice out there when it comes to crimpers... etc?

networker050184

Just buy some crimpers , a bag of RJ45 connectors and a role of CAT 5. It's a lot cheaper to build your own CAT 5 cables rather than buy them. Its also good to be able to change the ends as you need to instead of buying a whole new cable.

freetech

If you have a Home Depot or other home hardware store, they'll usually sell simple crimpers, good for occasional use, for ~$35 or less.
You can also get them mail ordered for ~$20. You can pick up the plugs/ends and some cable while you're at it.
Really is invaluable. When you need it, nothing else will do. And like everyone says, there's nothing like hands-on practice to help you remember!

yukky

Unfortunately, there are no Home Depot/Hardware stores around here.

I found this one:
41CWu5hThSL._SS500_.jpg

PLANEX RJ-45-8P

Does it seem good?

yukky

Do I need a more fancy one like this?

41KNH5RZSTL._SS500_.jpg

ELECOM LD-KKTR

lex0429

the second one looks like it has the RJ11 spot also along with the razor to cut wires or fingers or whatever.
the more simple one should suffice

Unfortunately, there are no Home Depot/Hardware stores around here.

freetech

Both of them will crimp an RJ-45 plug.
If you plan on doing a lot of your own cables, then get the second one - the nice one.
If you want to do a few for the experience, get the first, inexpensive one.
Always go with quality if you can afford it, but really either will do for occasional use.