Scsi drive not detected
Know this probably isn't the best setup for scsi drives but have a 50 pin adaptec controller that i'm trying to use 80 pin sca-2 drives with. Trying to get one drive detected, using a Scsi sca-2 to 50 pin adapter, everything is hooked up including the power connector on the sca-2 adapter but no drives are detected in the 'adaptec scsi-select' software. The drive is connected to the first connector on the cable after the controller card, the active terminator is on the next connector after the drive, is that correct or should the terminator be on the last connector on the cable?