03:30:02: %SYS-5-CONFIG_I: Configured from console
Jammywanks
Member Posts: 127
in CCNA & CCENT
Is there anyway I can turn these notifications off? As I am the only one modifying the configs on my dynamips labs I see no reason to see these annoying messages in the middle of typing a command!!! 
03:30:02: %SYS-5-CONFIG_I: Configured from console
03:30:02: %SYS-5-CONFIG_I: Configured from console
CCNA Lab: Two 1720's, one 2520, two 2924XL switches
[IPCop box] PIII 1GHz | 512MB RAM | 1 Gig Compact Flash HD
Errors in your CCNA text book? Never mind, the authors don't care.
[IPCop box] PIII 1GHz | 512MB RAM | 1 Gig Compact Flash HD
Errors in your CCNA text book? Never mind, the authors don't care.
Comments
-
shednik
Member Posts: 2,005
short versionJammywanks wrote:03:30:02: %SYS-5-CONFIG_I: Configured from consoleno logg con
full versionno logging console
-
Jammywanks
Member Posts: 127
Ok I will give it a shot. Thanks for the heads up.CCNA Lab: Two 1720's, one 2520, two 2924XL switches
[IPCop box] PIII 1GHz | 512MB RAM | 1 Gig Compact Flash HD
Errors in your CCNA text book? Never mind, the authors don't care. -
127.0.0.1
Member Posts: 53 ■■□□□□□□□□
I would recommend using the "logging synchronous" command. It shows these messages, but only after you hit the enter button.
To configure logging synchronous use the following commands:Router(config)#line cons 0 Router(config-line)#logging synchronous