Cisco 2600XM BOOT-2600XM-256 ROM Question

elegua

Hi Guys,

Can i use one BOOT-2600XM-256 on a 2650 router?, i have few 2650 running with 128 MB dram and i'm wondering if i can use them with 256 MB instead of 128 MB of dram.

Thanks in advance.

mikej412

No

mgeorge

The BOOT-2600XM-256 can be used in any 2600XM series.

If you have a Cisco 2600XM series that already has bootrom 12.2(8r) then you can
already upgrade to 256MB ram, as this is the required bootrom ver to support 256MB

If you have 12.2(7r) and below then you cannot upgrade to 256MB ram unless you
upgrade your bootroom to 12.2(8r)

2600 and 2600XM bootroms are not interchangable due to the speed of the routers ram bus, 2600's EDO's and operates at 100mhz, 2600XM's use SDRAM and operates at 125Mhz.
Ram is also not interchangable.

If you have a 2600XM and you want to see what RAM is in the router, use "Show c2600"
and it will display what ram is in what slot, works on 12.3 or greater, example;

DIMM Slot 0:
DIMM Type: Dual-Bank
DIMM Size: 64MBytes

DIMM Slot 1:
DIMM Type: Dual-Bank
DIMM Size: 64MBytes

You can see what bootrom you have by doing "sh ver"

Hope this clear up your confusion

mikej412

mgeorge27 wrote:

2600 and 2600XM bootroms are not interchangable due to the speed of the routers ram bus, 2600's EDO's and operates at 100mhz, 2600XM's use SDRAM and operates at 125Mhz.
Ram is also not interchangable.

Thanks for explaining it -- I was in a minimalist mood this morning

mgeorge

haha, I could tell your post consisted of 2 letters...

yukky

good thorough response.

elegua

Hi,

Thanks for the answers guys.