show ip mroute - rpf neighbor
aueddonline
Member Posts: 611 ■■□□□□□□□□
in CCNP
I am trying to work out the 'show ip mroute' output. The example in the book doesn't have IP addresses on the diagram so it's a bit confusing.
on a (S,G) entry on the RP is the RPF neighbor the next hop interface address to the source DR?
and is the (*,G) entry on the source DR, is the RPF neighbor the next hop interface address towards the RP?
on a (S,G) entry on the RP is the RPF neighbor the next hop interface address to the source DR?
and is the (*,G) entry on the source DR, is the RPF neighbor the next hop interface address towards the RP?
What's another word for Thesaurus?
Comments
-
miller811
Member Posts: 897
I am working through this myself, getting close to taking the exam.
These are the notes, that I took.
in the (S,G) source is the actual source address of the multicast traffic and the group is the actual multicast group itself.
Rpf neighbor entry is always all 0's when in sparse mode because an RP destination was configured statically.
Incoming interface: Serial0, RPF nbr 0.0.0.0I don't claim to be an expert, but I sure would like to become one someday.
Quest for 11K pages read in 2011
Page Count total to date - 1283