Router Diagnostics

Hey Guys,

Is there a built-in diagnostics in every cisco router? Say i want to check that all components are functioning properly. Currently i have pair of cisco 7507 and want to diagnose. What tools do you use?

I appreciate your comments.

Thank you,

Find more posts tagged with

Free for TechExams community: Cybersecurity salary guide

Compare cert salaries and plan your next career move

Button

Comments

scheistermeister

Well you can see the POST it goes through when it boots and then there is also show tech which is usually something that TAC asks for when you are having a problem.

mikej412

show diag

show tech-support

Paul Boz

Pretty much any show command will be helpful, as others have said.

Sh hardware is a good baseline for what's actually installed. Sh diag, as mike said, is good also.

Are you having a specific problem?

dtlokee

Also look at GOLD, not sure if it's supported on the model/rsp you have.

badsector

Hey guys,

Thanks to your comments, i appreciate a lot.
I missed this forum, I got my CCNA and MS cert in here. The last time i posted here it was last 2005 so i even forget my password but you guys are still supportive like before.

I'll try the commands, hope it works.

-- Paul Boz,

I got a system initiated restart on 1 box without any indication of the cause. The thing i remember is one of the PA's on those box is having intermittent ports. The last time i checked i did not find any intermittent port, its weird. So i just think if i can run router diagnostics to find the problem. Any tools or application you know to test or diagnose a router aside from the show commands in cisco?

What is GOLD?

Thank you,

astorrs

badsector wrote:

What is GOLD?

Generic OnLine Diagnostics (GOLD)

It's a diagnostic framework supported on some routers (and the Catalyst 6500's) covering bootup, health monitors, hardware faults, etc and supports manual or scheduled testing. I'm not very familiar with it (but I guess dtlokee is) as I've only seen it used by a colleague on a pair of new 6509E's with supe720-3CXL's that were recently installed for a client (VSS is awesome!).

Paul Boz

Okay well given the fact that you really aren't sure why the problem occurred, you may just have to wait for another failure to diagnose the problem. In the mean time, enable logging to a syslog server.

For more information on the commands available to do so, follow This link.

The basic configuration would be:

Router(config)#logging [address of server]
Router(config)#logging on

You can then select which trap levels you want to include in your syslogs with the following command:

R1(config)#logging trap [severity]

This way, whenever you experience a failure you will have a log of the event and can use it for diagnosis.

Eco

mikej412 wrote:

show tech-support

Oh god, I just did this on a 3550 and it's still going.

"show process cpu history" just flew by and that's a cool one. Learn something new everyday.

astorrs

Eco wrote:

mikej412 wrote:

show tech-support

Oh god, I just did this on a 3550 and it's still going.

You should try it on a fully populated 6509...

dtlokee

We use GOLD on all of our new 6500's and 4500's that we ship from integration as part of the burn in process. Different Supervisors and blades will support different tests on them and it can take anywhere from 30 minutes to 3 hours dependin on the test. An ASIC memory test takes the longest.