List of practice Labs

I am creating a list of practice labs for me to run through and i wanted to make sure i was covering everything i should need. let me know if theres anything i should add.

Switching
Lab 1 Analyze network traffic on PC
Lab 2 Walk through automated catalyst switch setup
Lab 3 Save and Erase configs
Lab 4 Setup passwords and hostname in manual setup
Lab 5 Setup Switch IP address
Lab 6 Setup SSH access for catalyst switch
Lab 7 Configure banners
Lab 8 Setup VLAN’s
Lab 9 Setup VTP
Lab 10 Troubleshoot VTP
Lab 11 Setup port security
Lab 12 Setup and verify STP
Lab 13 Troubleshoot VTP

Routing
Lab 14 Walk through automated setup
Lab 15 Save and Erase Configurations
Lab 16 Setup passwords and hostname in manual setup
Lab 17 Assign interface IP addresses
Lab 18 Examine routing table without any dynamic routing protocols
Lab 19 Configure default routes and static routes
Lab 20 IP subnetting (Written)
Lab 21 Setup, verify and troubleshoot RIP v2
Lab 22 Setup, verify and troubleshoot OSPF
Lab 23 Setup, verify and troubleshoot EIGRP
Lab 24 Setup, verify and troubleshoot inter-VLAN routing

WAN
Lab 24 Setup, verify and troubleshoot PPP
Lab 25 Setup, verify and troubleshoot Frame Relay
Lab 26 Setup, verify and troubleshoot NAT/PAT

Misc.
Lab 27 Setup, verify and troubleshoot Standard ACL’s
Lab 28 Setup, verify and troubleshoot Extended ACL’s

Find more posts tagged with

SAVE $250 on Your CISCO Boot Camp — Use Code "EXAM26"

Exclusively for TechExams members for Infosec Boot Camps starting before April 30, 2026

View CISCO Boot Camps

Comments

aragoen_celtdra

For what the CCNA asks for, this list should be plenty to practice with. If i can just add a reminder: make sure that for all the verification and troubleshooting labs that you do, pay good, close attention to the show commands as you will find this equally important as learning how to configure. You'll thank me too when you take your CCNA exam.

Panzer919

What are you going to run these labs with?

dynamik

Nice list. Are you going to break it down any more and add more details to each lab?

sprinkl3s

I plan to create my own little lab workbook with network diagrams and scenario's.

I have most of the book material done so now i'm going to drill away at some stuff on actual equipment and gns3.

And yes i plan to do a lot with debug and show commands.

stlsmoore

hmmm I like this list I think I'm going to go through these labs too once I finish the last few chapters of my book!

kevin31

sprinkl3s wrote: »

I plan to create my own little lab workbook with network diagrams and scenario's.

I have most of the book material done so now i'm going to drill away at some stuff on actual equipment and gns3.

And yes i plan to do a lot with debug and show commands.

Looks a good list seem to cover off most things.

Will you be sharing the book once finished?????