vlan 1 line up protocol down
laidbackfreak
Member Posts: 991
in CCNA & CCENT
ok guys ive just installed a 3750 G switch in for layer 3 routing
i can ping and conect via the intermediate address ok...
but the management ip address (Vlan 1) is showing as line up protocol down...
ive done the usual no shut etc but no joy...
now ive been doing a bit of googling and it appears i need to have a host plugged in before the vlan will come up....
is this normal ?? ive not come across it before....... so want to confirm thats the case before I go to the site and test this....
cheers
i can ping and conect via the intermediate address ok...
but the management ip address (Vlan 1) is showing as line up protocol down...
ive done the usual no shut etc but no joy...
now ive been doing a bit of googling and it appears i need to have a host plugged in before the vlan will come up....
is this normal ?? ive not come across it before....... so want to confirm thats the case before I go to the site and test this....
cheers
if I say something that can be taken one of two ways and one of them offends, I usually mean the other one :-)
Comments
-
jafar2048
Member Posts: 2 ■□□□□□□□□□
As far as I know, at least one host has to be plugged into one of the switch ports. You can try this scenario by using PacketTracer.
Regards,