two NIC cards

I want to have two different IP address on one computer, to do this can I just intall two different NIC cards in one PC?

Find more posts tagged with

Free for TechExams community: Cybersecurity salary guide

Compare cert salaries and plan your next career move

Button

Comments

methoselah

yes. "Multi-homed".

Or if you want, you can just add another address to the one NIC in TCP/IP properties.

sab4you

yes.

If your using a windows network though you will have to turn off Nebios on one of the nic cards (if both nics are in the same network).

cellophanecore

could I put 3 nics in? what is the max?

Webmaster

cellophanecore wrote:

what is the max?

The number of slots in your PC

cellophanecore

so then when you do a ping on your computer, how does the computer know what NIC or ip address you are pinging from?

cellophanecore

anyone?

Webmaster

Depends where you are pinging to, what the default gateway is, and the contents of the local routing table (run the route print command on the command line in Windows).

For example, if you have a computer with two nics, one is pointing to your cable/xDSL router (the Internet), and the other is connect to a local network with the IP range: 192.168.2.0. The routing table will contain the route for the local attached networks including the interfaces they are connected to. So if you ping to 192.168.2.115, your computer will know that it must send the packets out of the interface connected to the 192.168.2.0 (that interface could be 192.168.2.1 for example).
Traffic other than that will be send to the default gateway address, which in this situation the computer would receive from the cable/xDSL modem/router/ISP by DHCP. (note the 0.0.0.0 route in the routing table).

I hope this helps!

Fire Starter

Hi Johan, would it be possible to put up a schematic of a home lab with one PC/laptop with 2 NICs and a couple of routers ?

Also would you need to run two sessions of hyperterminal ?

rossonieri#1

you can do your routers with 1 laptop via telnet - if your routers have already configured, have all their ip address and your access ( password ). if you dont, you have to configure them by console connection ( roll cable thing ).

Fire Starter

Hi Dedy, sounds pretty good, is it possible to achieve CCNA with that setup and two 803 routers, bearing in mind they have no WIC 1T slots just ethernets. Thanks

schneeman

Fire Starter wrote:

Hi Johan, would it be possible to put up a schematic of a home lab with one PC/laptop with 2 NICs and a couple of routers ?

Also would you need to run two sessions of hyperterminal ?

You can use telnet dedy also said that thing.But if you want to use two rollover cable on to the connect routers with console port.dont think that.Because two rollover cable never work with same time on two nic on the same computer.

rossonieri#1

remember my friend, the first thing you have to configure to start a router is configure it via console, right?? ( console connected by your serial port on your pc with roll cable ) configure your ip add etc... i did not mean that one roll cable thing will go to routers... - you will do it one at a time just to configure your router ip(s)... because telnet will use that ip. and after your routers start succesfully you can just unplugged your roll cable and leave your router running... and you configure your routers via telnet then. telnet routerIP -