WIC-1t problem on 1603 and 2611,2620

linux44linux44 Member Posts: 38 ■■□□□□□□□□
in CCNA & CCENT
hello
i have bought a WIC-1t and have been trying for 8 hours to get it working with no luck
on all of the routers it give me the following command:
Unknown WAN daughter card
have done some googling and some people advice to update the IOS which i have done and here is list of some of the ios that i have used
c2600-ik9o3s3-mz.122-15.T17
c2600-ik9o3s3-mz.123-25
c2600-ik9o3s3-mz.123-25
c2600-ik8o3s-mz.122-11.T
and still no luck
i can see the int on sh diag but not on sh run or sh ip int b
the other massege that apper at the proccess of boot
WIC in slot(0/0), wic card has an unknown id of 0xFF
Unknown WIC in slot(0/1), wic card has an unknown id of 0xFF



please help as i need to get this working asap
· Share on FacebookShare on Twitter

Comments

  • tierstentiersten Member Posts: 4,505
    Check connector. Are you pushing it all the way in?

    If so then you've got a dead WIC.
    · Share on FacebookShare on Twitter
  • linux44linux44 Member Posts: 38 ■■□□□□□□□□
    yes but still i get no led

    the guy i have bought it from has tooken them out from 1700 serias router and he said they are workingis

    any suggestion
    is there any configuration that need to be done
    · Share on FacebookShare on Twitter
  • jmc012jmc012 Member Posts: 134
    linux44 wrote: »
    yes but still i get no led

    the guy i have bought it from has tooken them out from 1700 serias router and he said they are workingis

    any suggestion
    is there any configuration that need to be done

    So when you do a #show ip int br they aren't listed? When I installed mine they showed up automatically, I just needed to do the normal config like adding a ip address, clock rate and a no shut.
    · Share on FacebookShare on Twitter
  • tierstentiersten Member Posts: 4,505
    linux44 wrote: »
    is there any configuration that need to be done
    No. There isn't anything to configure to get the router to detect the card. You shouldn't get the error about unknown ID either.
    · Share on FacebookShare on Twitter
  • blackninjablackninja Member Posts: 385
    I have see this error when the card is a chinese copy, has yours the cisco hologram?
    Currently studying:
    CCIE R&S - using INE workbooks & videos

    Currently reading:
    Everything. Twice ;)
    · Share on FacebookShare on Twitter
  • linux44linux44 Member Posts: 38 ■■□□□□□□□□
    it wrote on it
    made in singapore
    but i can not see the cisco hologrom on it but what i can see is that ,it wrote copy right cisco system
    · Share on FacebookShare on Twitter
  • tierstentiersten Member Posts: 4,505
    linux44 wrote: »
    it wrote on it
    made in singapore
    but i can not see the cisco hologrom on it but what i can see is that ,it wrote copy right cisco system
    Send it back for a refund.
    · Share on FacebookShare on Twitter
Sign In or Register to comment.