Quick GNS3 Question - Frame Relay Switch?

redwarrior

Hey Guys!

I'm trying to set up a quick little frame-relay network in order to practice OSPF in a NBMA network. The problem is that I can't seem to get any connectivity between my routers and the built-in frame relay switch. For one thing, are my routers the source or destination as far as the DLCI's shown in the frame-relay switch configuration in GNS3? For another, do we know what LMI type and encapsulation the frame relay switch is using? (Cisco vs. ietf?)

I have read some posts elsewhere saying that it's best to skip the built-in frame-relay switch and simply configure a router as your frame-relay switch, but I'm not that familiar with a provider-side frame configuration. Would I configure as usual, just set my frame-relay switch router as the DCE rather than the DTE?

Meh. I guess I gotta learn more about frame-relay before I get to play more with OSPF...

kryolla

for the DTE end it will auto-detect LMI type and once that happens you will know what DLCI the switch is sending to you. All you need to do on the DTE end is encap frame relay. Here is a sample config for an interface on a FR switch. The DTE end connected to this interface will get DLCI 102-105

interface Serial0
no ip address
encapsulation frame-relay
clockrate 64000
frame-relay intf-type dce
frame-relay route 102 interface Serial1 201
frame-relay route 103 interface Serial2 301
frame-relay route 104 interface Serial4 401
frame-relay route 105 interface Serial5 501
no shut