Can I use UC500 Software onf 2610xm Router?

malikhan292

Hi,
I am underway of preparing CCNA-Voice. I have not seen much information about practicing UC500 without purchasing the actual hardware?

Can some one advise If I can simulate UC500 (to get GUI access and CLI) and integrate into the network? Or Is this possible to run UC500 Software on other ISR routers or 2610XM?

Thanks,
Ali

pitviper

malikhan292 wrote: »

Hi,
I am underway of preparing CCNA-Voice. I have not seen much information about practicing UC500 without purchasing the actual hardware?

Can some one advise If I can simulate UC500 (to get GUI access and CLI) and integrate into the network? Or Is this possible to run UC500 Software on other ISR routers or 2610XM?

Thanks,
Ali

Not possible - The Cisco Configuration Assistant (CCA) currently only works with the UC platform. Hands on would be the best bet but other have mentioned studying various GUI images (Cisco Press book and CBT videos) to familiarize themselves with the location of configuration items. CME via the command line however is exactly the same between the 2.