Cisco NM-4T or NM-4A/S?

Hello, is it true the the 2600 Series doesn't support the NM-4T, and only the 3600 supports it? I read that the 2600 only supports NM-4A/S, true? I have read also that the difference between the NM-4T and NM-4A/S is that the first only supports Synchronous and High Speed Serial Connections and the later supports Synchronous and Asynchronous Low Speed Serial Connections, true also? Thx In Advance guys...

Find more posts tagged with

Save $250 on 2025 certification boot camps from Infosec!

Book now with code EOY2025

Button

Comments

astorrs

Assuming this is for a lab environment, speed should be a non-issue for you and the A/S works fine (usually cheaper too).

cerberos

astorrs wrote: »

Assuming this is for a lab environment, speed should be a non-issue for you and the A/S works fine (usually cheaper too).

I fully agree with u, but I do have 2600XM and the NM-4T is not compatible with it, correct me if I'm wrong please... Thx in advance.

jason_lunde

The 4T will not work with those models. You must use the 4A/S.

http://www.cisco.com/en/US/products/hw/routers/ps274/products_tech_note09186a00800a93f3.shtml

...check the table about halfway down

Hope this helps, I found out the hard way.

cerberos

jason_lunde wrote: »

The 4T will not work with those models. You must use the 4A/S.

This is exactly what I'm talking about, thx...