NM-4A/S module install 2620xm

Okay try setting this in the router. THe lights light up on the serial and then during boot there is a IOS crash. I am going to try and reset it and see if it happens again. anything particular I am doing wrong?

Find more posts tagged with

Comments

tiersten

Its a bad NM or its not seated properly.

thenjduke

was not seated properly. I figure it was something so simple. I am glad that is all worked out. Almost got all the routers setup. I am so happy. now just need one more switch.

thenjduke

*Mar 1 00:14:28.147: %CIRRUS-3-HWNORESPONSE: The CD2430 Controller is not responding, power cycle the router
*Mar 1 00:14:28.147: %SYS-3-CPUHOG: Task ran for 3000 msec (0/0), process = Serial Background, PC = 80010DF8.
-Traceback= 80010DFC 804942C0 804977E8

this is the message I am getting

mikej412

thenjduke wrote: »

*Mar 1 00:14:28.147: %CIRRUS-3-HWNORESPONSE: The CD2430 Controller is not responding, power cycle the router

Cisco IOS System Messages, Volume 1 of 2 - CI through COT [Cisco IOS Software Releases 12.3 Mainline] - Cisco Systems

Error Message

%CIRRUS-3-HWNORESPONSE : The CD2430 Controller is not responding, power cycle the router

Explanation The CD2430 controller has failed to respond to the user request. This condition is due to unsupported clocking or the use of a nonstandard cable.

Recommended Action Check the clocking and cable. Use Cisco cables only. If this message recurs, copy the error message exactly as it appears on the console or in the system log, contact your Cisco technical support representative, and provide the representative with the gathered information.

thenjduke

I was able to get it. Thank everyone.