config-register

Fire StarterFire Starter Posts: 14Member ■□□□□□□□□□
Hi I'm getting this error message on one lab.

GAD(config)#config-register 0x2102
GAD(config)# exit
GAD(config)# copy run start

Destination filename [startup-config] ? [Enter]
GAD# reload
Proceed with reload? [confirm] [Enter]

00:04:27: %SYS-5-RELOAD: Reload requested
System Bootstrap, Version 11.3(2)XA4, RELEASE SOFTWARE (fc1)
Copyright (c) 1999 by cisco Systems, Inc.
TAC:Home:SW:IOS:Specials for info
C2600 platform with 65536 Kbytes of main memory

program load complete, entry point: 0x80008000, size: 0x3e1c90
Self decompressing the image :: ####

#####
# [OK]
boot of "gsnew-image" using boot helper "flash:c2600-d-mz.120-2.xc2.bin" failed
error returned: File boot failed -- File not accessible
loadprog: error - on file open
boot: cannot load "gsnew-image"

System Bootstrap, Version 11.3(2)XA4, RELEASE SOFTWARE (fc1)
Copyright (c) 1999 by cisco Systems, Inc.
TAC:Home:SW:IOS:Specials for info
C2600 platform with 65536 Kbytes of main memory

program load complete, entry point: 0x80008000, size: 0x3e1c90
Self decompressing the image : #####

.......

16384K bytes of processor board System flash (Read/Write)fc1)

Configuration register is 0x3922o Systems, Inc.


Now.....once the router has rebooted, it should boot from NVRAM

GAD# sh ver should give 0x2102 as the config-register but it has 0x3922

??????

Any feedback would be much appreciated.

BTW, Its set at 115200 baud instead of 9600.

icon_redface.gif

Comments

  • keenonkeenon Posts: 1,921Member ■■■■□□□□□□
    thats interesting i haven't seem that before..
    question when your saving does it really look like
    GAD(config)# copy run start

    [/list][/url]
    Become the stainless steel sharp knife in a drawer full of rusty spoons
  • Max4SpeedMax4Speed Posts: 1Member ■□□□□□□□□□
    Just trying to get an idea, what exactly are you trying to do? I didnt see the INITIALIZE command up there.
    Trying to Study for CCNA!
Sign In or Register to comment.