cisco 2610 Frame Relay?

in CCNA & CCENT
Hi Cisco crew,
i was thinking of getting a 2610 for a frame relay setup. will i still need a TRANSCEIVER? please let me know if this is a good router for it or any suggestions on what to get to complete frame relay.
thanks and god bless
i was thinking of getting a 2610 for a frame relay setup. will i still need a TRANSCEIVER? please let me know if this is a good router for it or any suggestions on what to get to complete frame relay.
thanks and god bless
Comments
-
kalebksp Member Posts: 1,033 ■■■■■□□□□□
The only built in port on a 2610 is a single ethernet. You'll need WICs or an NM to use it for frame relay. If you want to use it as a frame relay switch you'll probably want to get a NM-4A/S or a couple WIC-2Ts. You won't need a transceiver though. -
dynamik Banned Posts: 12,312 ■■■■■■■■■□
You won't need a transceiver, but you'll have to get one of these: Understanding 4- and 8-Port Async/Sync Network Modules - Cisco Systems
Edit: Too slow for Kalebksp -
Bl8ckr0uter Inactive Imported Users Posts: 5,031 ■■■■■■■■□□
you smart people respond quick. many thanks
I got a 2610 with an 4 A/S for a little less than 100 -
peanutnoggin Member Posts: 1,096 ■■■□□□□□□□
As previous posters have stated... you'll need the NM-4A/S and the 2610 will run perfectly. This is currently what I use as a Frame Relay Switch. HTH
~PeanutWe cannot have a superior democracy with an inferior education system!
-Mayor Cory Booker