Aruba AP-60
eng_ahmedas
Member Posts: 69 ■■□□□□□□□□
Dear Friends
I wish u r fine ...... I am confused about something and i want a help from u ..... I will buy 2 APs AP-60 that i want to use them in (point-to-point)PTP mode(The scienario is i have 2 buildings and i want to connect them using 2 access points in PTP mode)
My question is: Can the access point AP-60 works as indoor AP (serve client and permit client assossiation to it) while working in PTP mode with the other access point ???
Thanks in advance
I wish u r fine ...... I am confused about something and i want a help from u ..... I will buy 2 APs AP-60 that i want to use them in (point-to-point)PTP mode(The scienario is i have 2 buildings and i want to connect them using 2 access points in PTP mode)
My question is: Can the access point AP-60 works as indoor AP (serve client and permit client assossiation to it) while working in PTP mode with the other access point ???
Thanks in advance
Comments
-
JDMurray
Admin Posts: 13,101 Admin
Have you checked with an Aruba sales associate?
I would assume because the antenna configuration for PTP and wide-area coverage are so different (dish/grid antenna vs. panel/dipole antenna) that one AP can't serve as both. However, only Aruba can say for sure. -
djmd
Member Posts: 48 ■■□□□□□□□□
Probably late on this, but I don't believe you can do this. Typically you are going to not only need an AP that can do 2 radios concurrently (AP65, AP70 for instance) but you're also going to need a mesh license for your controller, and you'll need to turn the "root" AP into a mesh portal. Good luck!