Options
Frame Relay
imsisko
Member Posts: 32 ■■□□□□□□□□
in CCNA & CCENT
Is there any difference between these two config commands and if yes what?
interface serial 0/1.102 point-to-point
interface serial 0/1.102
Do I need to use the point-to-point or it is just optional?
thanks!!
interface serial 0/1.102 point-to-point
interface serial 0/1.102
Do I need to use the point-to-point or it is just optional?
thanks!!
Comments
-
OptionsCiskHo Member Posts: 188Been awhile since I went over FR but for a quick check you could run this to find out:
"interface serial 0/1.102 ?"
If you see "<cr>" then the point-to-point addition is optional.My Lab Gear:
2811(+SW/POE/ABGwifi/DOCSIS) - 3560G-24-EI - 3550-12G - 3550POE - (2) 2950G-24 - 7206VXR - 2651XM - (2) 2611XM - 1760 - (2) CP-7940G - ESXi Server
Just Finished: RHCT (1/8/11) and CCNA:S (Fall 2010)
Prepping For: VCP and CCNP SWITCH, ROUTE, TSHOOT -
Optionsimsisko Member Posts: 32 ■■□□□□□□□□Why didn't I think of that??
C2610-XM-R2(config)#int s0/0.100
% Incomplete command.
C2610-XM-R2(config)#int s0/0.100 ?multipoint Treat as a multipoint link
point-to-point Treat as a point-to-point link
Thanks! I need to get one more router so I can config subinterfaces too!