My router is trying to find a startup-config from TFTP?
spartangtr
Member Posts: 111
in CCNA & CCENT
Trying to start fresh settin up my 2610, runnin through a few labs. Did "erase start-config" then a "reload". This is what i'm getting when it boots up now. It looks like maybe it's trying to pull a config from a TFTP server? Shouldn't it just go straight into setup mode? How do I get around this?
Not sure what I did to cause that. The config register is set at 0x2102.
Not sure what I did to cause that. The config register is set at 0x2102.
Comments
-
spartangtr Member Posts: 111In configuration mode type:
no service config
Alright, i'll plug that into the config. Is that a default? Never have seen that that command before.... -
Dilbert65 Member Posts: 73 ■■□□□□□□□□it depends on the IOS. Once I upgraded my IOS's this silly message started showing up. Now I just add that to my base config.