cme block certain number with COR

softestpleasesoftestplease Member Posts: 14 ■□□□□□□□□□
Hi guys,

How to block one certain number(1005) in dial peer range "internal calls" on CME using COR?
for example...

dial-peer voice 1000 voip
destination-pattern 100[0-9]
session target ipv4:10.0.0.7
codec g711ulaw

Thanks in advance

Comments

  • peanutnogginpeanutnoggin Member Posts: 1,096 ■■■□□□□□□□
    Can't you do:

    dial-peer voice 1000 voip
    destination-pattern 100[012346789]
    session target ipv4:10.0.0.7
    codec g711ulaw


    I'm just getting into the voice, so this may not be the best way, but I think it would have the desired outcome. Someone with more knowledge than me can attest to this. HTH.
    We cannot have a superior democracy with an inferior education system!

    -Mayor Cory Booker
  • chmorinchmorin Member Posts: 1,446 ■■■■■□□□□□
    Is COR even a voice topic?
    Currently Pursuing
    WGU (BS in IT Network Administration) - 52%| CCIE:Voice Written - 0% (0/200 Hours)
    mikej412 wrote:
    Cisco Networking isn't just a job, it's a Lifestyle.
  • azaghulazaghul Member Posts: 569 ■■■■□□□□□□
    COR is a voice topic, it's part of CVOICE in CCVP.
  • chmorinchmorin Member Posts: 1,446 ■■■■■□□□□□
    azaghul wrote: »
    COR is a voice topic, it's part of CVOICE in CCVP.

    RIGHT okay then it was what I thought it was. I just wanted to make sure I didn't have to study it for my CCNA Voice IIUC.
    Currently Pursuing
    WGU (BS in IT Network Administration) - 52%| CCIE:Voice Written - 0% (0/200 Hours)
    mikej412 wrote:
    Cisco Networking isn't just a job, it's a Lifestyle.
Sign In or Register to comment.