DTE Unknown (13) clocks stopped

sndp_2002

I have a 2621XM with IOS 12.4(16a) and have installed a wic-2t it is being recognized and i an able to configure the interfaces but I am using the router as my internet router to connect to my ISP. the status of the interface is showing up but protocol is down. When I do show controllers i notice "DTE Unknown (13) clocks stopped" THe ISP provides the clock can someone please advice me on how I can get this to work?

Find more posts tagged with

Free for TechExams community: Cybersecurity salary guide

Compare cert salaries and plan your next career move

Button

Comments

Dilbert65

See if this help. WIthout know more of the config and setup hard to pin point.

Troubleshoot V.110 Connections on Cisco Access Servers [Asynchronous Connections] - Cisco Systems

alan2308

The only thing I can find about that error message is a thread from a while back on here. It turned out to be a bad WIC. Do you have any other WIC you can swap in to see?

http://www.techexams.net/forums/ccna-ccent/8912-2610-wic-2t-connection-problems.html

wbosher

I was thinking hardware problem too, but it says status of the interface is showing up but protocol is down. Wouldn't this indicate that physically that the interface is ok? Just a layer 2 problem?

chmorin

wbosher wrote: »

I was thinking hardware problem too, but it says status of the interface is showing up but protocol is down. Wouldn't this indicate that physically that the interface is ok? Just a layer 2 problem?

I would assume there can be more things physically wrong wit the wic that would still allow it to show as 'up'. Trade out wic's to be safe.

wbosher

chmorin wrote: »

I would assume there can be more things physically wrong wit the wic that would still allow it to show as 'up'. Trade out wic's to be safe.

I just thought that if there was a physical problem it would show as down/down, not up/down.

gprasadb

Any updates on this? i am also facing the same issue 'DTE Unknown (13) clocks stopped'. I have swapped the WIC1T but still the same error so its not a hardware issue.

Could anyone help me on this