RP mapping agent
high1432007
Member Posts: 37 ■■□□□□□□□□
in Juniper
In multicast lab ,I found an autorp mapping agent（just mapping agent ,no local rp config ）can't learn RP from itself .
How to solve this problem , and I can't configure "set protocols pim rp auto-rp discovery" with "set protocols pim rp auto-rp mapping" at same time
am using 8.5S3.... does anybody encouter similar issue.
How to solve this problem , and I can't configure "set protocols pim rp auto-rp discovery" with "set protocols pim rp auto-rp mapping" at same time
am using 8.5S3.... does anybody encouter similar issue.
Comments
-
hoogen82
Member Posts: 272
Post some configs and some show commands for us to see...IS-IS Sleeps.
BGP peers are quiet.
Something must be wrong. -
high1432007
Member Posts: 37 ■■□□□□□□□□
Ok, will do, but can you try to input both command under protocol pim together in your test bed first
"set protocols pim rp auto-rp discovery"
"set protocols pim rp auto-rp mapping" -
hoogen82
Member Posts: 272
Seriously?? I am just trying to help here... Never mind...Good luck with your lab..IS-IS Sleeps.
BGP peers are quiet.
Something must be wrong. -
Robert_74
Member Posts: 38 ■■□□□□□□□□
high1432007 wrote: »Ok, will do, but can you try to input both command under protocol pim together in your test bed first
People here simply try to help and not after one's favor ... in terms of OK
As far as your question concerned, to learn RP "from itself" this RP has to be configured "on itself", as a minimum. Then, mapping already implies discovery which means when you type 'auto-rp discovery' you enable announce, discover and mapping. -
oxzgan
Member Posts: 44 ■■□□□□□□□□
high1432007 wrote: »Ok, will do, but can you try to input both command under protocol pim together in your test bed first
"set protocols pim rp auto-rp discovery"
"set protocols pim rp auto-rp mapping"
i cant see this commnd exists ..any idea why this command used
