Options
Cisco Command and Non cisco SFP Modules
laidbackfreak
Member Posts: 991
in Off-Topic
Anyone know off hand what the command is to allow non cisco sfp modules to be used in cisco switches?
Ignore I found it :-
switch(config)# service unsupported-transceiver
switch(config)# no errdisable detect cause gbic-invalid
Ignore I found it :-
switch(config)# service unsupported-transceiver
switch(config)# no errdisable detect cause gbic-invalid
if I say something that can be taken one of two ways and one of them offends, I usually mean the other one :-)
Comments
-
Optionslaidbackfreak Member Posts: 991True but it exists on the nexus so that gets me out of a hole for now. I can't believe there being so cheap over a couple sfp module's v the cost of the nexus !if I say something that can be taken one of two ways and one of them offends, I usually mean the other one :-)