OSPF question

OK, I have three 1841 with a t1 module installed. I am currently running EIGRP on the ethernet connections with no issues. I setup OSPF on the serial links between two of the routers. The packets are being exchanged but when I run sh ip route nothing is indicated in the table. The EIGRP protocol does show up.

Find more posts tagged with

Save $250 on 2025 certification boot camps from Infosec!

Book now with code EOY2025

Button

Comments

deth1k

do you have both of them running?if so eigrp ad>ospf ad(90>110)

shodown

lochmoigh wrote: »

OK, I have three 1841 with a t1 module installed. I am currently running EIGRP on the ethernet connections with no issues. I setup OSPF on the serial links between two of the routers. The packets are being exchanged but when I run sh ip route nothing is indicated in the table. The EIGRP protocol does show up.

1. EIGRP has a lower AD than OSPF
2. Serial links are direclty connected there for no routes will show up
3. Add some loopbacks and put them in OSPF
4. This was typed out fast so others please check for errors.

Stotic

Administrative distance - Wikipedia, the free encyclopedia

lochmoigh

oh yeah, makes sense. Thanks.