IPv6 over L3 etherchannel

fonque

I am trying to build the TSHOOT topology at home and hit a snag. I cannot get ipv6 connectivity to work over an L3 etherchannel at all and I cant figure out why. IPv4 connectivity works just fine. EIGRP is passing updates without issue. However, I cannot even get an IPv6 ping across that etherchannel. I am using 2 3550's for this connection. Below are the configs:

MLS1#
interface Port-channel12
no switchport
ip address 10.2.4.13 255.255.255.252
ipv6 address 2026::3:1/122
ipv6 enable
ipv6 rip RIP_ZONE enable

interface FastEthernet0/23
no switchport
no ip address
ipv6 enable
channel-group 12 mode desirable

interface FastEthernet0/24
no switchport
no ip address
ipv6 enable
channel-group 12 mode desirable
end

====================================
MLS2#
interface Port-channel12
no switchport
ip address 10.2.4.14 255.255.255.252
ipv6 address 2026::3:2/122
ipv6 enable
ipv6 rip RIP_ZONE enable

interface FastEthernet0/23
no switchport
no ip address
ipv6 enable
channel-group 12 mode desirable

interface FastEthernet0/24
no switchport
no ip address
ipv6 enable
channel-group 12 mode desirable
end


Any help is very much appreciated!

stuh84

I was under the impression IPv6 didn't work on 3550s. Even if you can put the commands in, I don't think it works.