Show Version - how much memory is this ?

Zonian18

Hey guys
I'm not 100% sure on how much DRAM this 2611 has.
I have the show version below

Is it the 36864K/4096K added together to make 40MB ?

Or is it the 32K bytes of non-volatile configuration memory (32MB)

Thanks !

R1#show version
Cisco Internetwork Operating System Software
IOS (tm) C2600 Software (C2600-I-M), Version 12.3(9), RELEASE SOFTWARE (fc2)
Copyright (c) 1986-2004 by cisco Systems, Inc.
Compiled Fri 14-May-04 14:37 by dchih
Image text-base: 0x80008098, data-base: 0x80CC08C4

ROM: System Bootstrap, Version 11.3(2)XA4, RELEASE SOFTWARE (fc1)

R1 uptime is 26 minutes
System returned to ROM by reload
System image file is "flash:c2600-i-mz.123-9.bin"

cisco 2611 (MPC860) processor (revision 0x202) with 36864K/4096K bytes of memory.
Processor board ID JAD03379005 (3519272710)
M860 processor: part number 0, mask 49
Bridging software.
X.25 software, Version 3.0.0.
2 Ethernet/IEEE 802.3 interface(s)
2 Serial network interface(s)
32K bytes of non-volatile configuration memory.
8192K bytes of processor board System flash (Read/Write)

Configuration register is 0x2102

tomaifauchai

36864K + 4096K

36864 for IOS loaded into ram and system processes
4096 for packets

hermeszdata

Zonian18 wrote: »

Hey guys
I'm not 100% sure on how much DRAM this 2611 has.
I have the show version below

Is it the 36864K/4096K added together to make 40MB ?

Or is it the 32K bytes of non-volatile configuration memory (32MB)

Thanks !

If you were to open the case, you would find that you have 1 32MB Stick and 1 8MB stick of DRAM. You also have 8MB Flash. I would definitely upgrade by replacing the 8MB DRAM module with another 32MB module and upgrade the flash to 16MB (requires module replacement).

Zonian18

Thanks for the reply

Do you recommend any good/legit places to purchase memory for routers/switches etc?

I've seen stuff on ebay but an actual site is just a lot easier to deal with.

tomaifauchai

Memory upgrades for Cisco Equipment CablesAndKits.com Cisco Memory