Stuck at (boot) prompt
kadshah
Member Posts: 388 ■■■□□□□□□□
in CCNA & CCENT
I was doing an excercise on restoring the router configuration and messed up. When I ran the copy tftp flash it downloaded correctly then i tried the copy tftp run and I ran into problems. Here's the problem i'm stuck at the kaj(boot) prompt.
What's the meaning of this? How do I return to either the user exec mode kaj> or privileged mode kaj#
Ex.
kaj(boot)#sh ver
Cisco Internetwork Operating System Software
IOS (tm) 3000 Bootstrap Software (IGS-RXBOOT), Version 10.2(8a), RELEASE SOFTWARE (fc1)
Copyright (c) 1986-1995 by cisco Systems, Inc.
Compiled Tue 24-Oct-95 15:46 by mkamson
Image text-base: 0x01020000, data-base: 0x00001000
ROM: System Bootstrap, Version 5.2(8a), RELEASE SOFTWARE
kaj uptime is 25 minutes
System restarted by power-on
Running default software
cisco 2500 (68030) processor (revision N) with 14332K/2048K bytes of memory.
Processor board serial number 05604483 with hardware revision 00000000
X.25 software, Version 2.0, NET2, BFE and GOSIP compliant.
1 Ethernet/IEEE 802.3 interface.
2 Serial network interfaces.
32K bytes of non-volatile configuration memory.
16384K bytes of processor board System flash (Read/Write)
Configuration register is 0x2102
kaj(boot)#
What's the meaning of this? How do I return to either the user exec mode kaj> or privileged mode kaj#
Ex.
kaj(boot)#sh ver
Cisco Internetwork Operating System Software
IOS (tm) 3000 Bootstrap Software (IGS-RXBOOT), Version 10.2(8a), RELEASE SOFTWARE (fc1)
Copyright (c) 1986-1995 by cisco Systems, Inc.
Compiled Tue 24-Oct-95 15:46 by mkamson
Image text-base: 0x01020000, data-base: 0x00001000
ROM: System Bootstrap, Version 5.2(8a), RELEASE SOFTWARE
kaj uptime is 25 minutes
System restarted by power-on
Running default software
cisco 2500 (68030) processor (revision N) with 14332K/2048K bytes of memory.
Processor board serial number 05604483 with hardware revision 00000000
X.25 software, Version 2.0, NET2, BFE and GOSIP compliant.
1 Ethernet/IEEE 802.3 interface.
2 Serial network interfaces.
32K bytes of non-volatile configuration memory.
16384K bytes of processor board System flash (Read/Write)
Configuration register is 0x2102
kaj(boot)#
Comments
-
kadshah
Member Posts: 388 ■■■□□□□□□□
never mind i just figure it out.I interrupted the boot sequence using the ctrl+break then typed o followed by o/r and the new register value 0x2102 hit enter reboot and everything back to normal at least now i know and hopefully i'llnever forget.