Help configuring enable password

alkamalju

I have a 2811 router with IOS version: 2800 Software (C2800NM-IPBASE-M), Version 12.4(15)T13, RELEASE SOFTWARE (fc3).

i have the following authentication configuration:

===================
username admin privilege 7 password 7 110A1016141D
===================l
ine con 0
password 7 045802150C2E
login
line aux 0
line vty 0 4
privilege level 15
password cisco
login
transport input telnet
!
scheduler allocate 20000 1000
!
end
====================


Problem is, I was expecting the router to prompt me for username "admin" and password "cisco" and also to ask for enable password "cisco". However, it only ask for a single password once and get into the admin mood like this:


================
User Access Verification

Password:
TEST_RT1#show run
===============

Need help about how i can set my router to ask for username "admin"

masterk

I think you need to enter the command "login local" under line console 0 to make it use usernames configured on that router.

MosGuy

As masterk suggests. You can set the router to use the local username database. By going under console 0 or vty lines and issuing the: "login local" command instead of just login (which only prompts for a password).

Jas21

admin mood!

alkamalju

Thanks everyone.