Help Faulty WIC-2T card ?
johnnyarks
Member Posts: 136 ■■■□□□□□□□
in CCNA & CCENT
So I recently bough 5 WIC-2T cards from ebay (not all together) for ~$28 each. 2 diff sellers.
One of these card has its LED link light lit up before I even put a serial cable in it, I checked the port and with serial cable plugged in, it reads the following
"Interface Serial0/1
Hardware is PowerQUICC MPC860
No serial cable attached
idb at 0x815C0058, driver data structure at 0x815C7E2C
SCC Registers:
General [GSMR]=0x2:0x00000030, Protocol-specific [PSMR]=0x8
Events [SCCE]=0x0000, Mask [SCCM]=0x001F, Status [SCCS]=0x00
Transmit on Demand [TODR]=0x0, Data Sync [DSR]=0x7E7E"
the other Serial(s0/0) port on the same WIC-2T card reads the Serial cable just fine...but doesn't receive clocking single correctly I tried, it "flip flops, line up,down... up, down..." it this card just bad, any clues...or funky commands I can tried to make sure this thing is useless ? I already complained to the seller, he sold me 3 cards, 1 works normally, 1 was doa, and the other is the one in question...
help
One of these card has its LED link light lit up before I even put a serial cable in it, I checked the port and with serial cable plugged in, it reads the following
"Interface Serial0/1
Hardware is PowerQUICC MPC860
No serial cable attached
idb at 0x815C0058, driver data structure at 0x815C7E2C
SCC Registers:
General [GSMR]=0x2:0x00000030, Protocol-specific [PSMR]=0x8
Events [SCCE]=0x0000, Mask [SCCM]=0x001F, Status [SCCS]=0x00
Transmit on Demand [TODR]=0x0, Data Sync [DSR]=0x7E7E"
the other Serial(s0/0) port on the same WIC-2T card reads the Serial cable just fine...but doesn't receive clocking single correctly I tried, it "flip flops, line up,down... up, down..." it this card just bad, any clues...or funky commands I can tried to make sure this thing is useless ? I already complained to the seller, he sold me 3 cards, 1 works normally, 1 was doa, and the other is the one in question...
help