Options
VTP version 2 Question?
vazurahan
Member Posts: 23 ■□□□□□□□□□
in CCNA & CCENT
Based on the show vtp status command on a switch with clean configuration. The switch has a VTP V2 Mode: Disabled.
So that would mean that if I set the switch to Transparent Mode, it won't forward VTP messages unless it belongs to the same domain and have the same password, right?
If I'm going to change it to version 2, do I have to change all of the other switches setting to version 2?
On production networks, do you guys usually change the VTP version mode to 2?
So that would mean that if I set the switch to Transparent Mode, it won't forward VTP messages unless it belongs to the same domain and have the same password, right?
If I'm going to change it to version 2, do I have to change all of the other switches setting to version 2?
On production networks, do you guys usually change the VTP version mode to 2?
Comments
-
Optionspham0329
Member Posts: 556
Yes, VTP version 1 only forwards if domain/password is correct. Once you enable VTP version 2 on the server, all other switches in the domain will run V2.
-
Optionsvazurahan
Member Posts: 23 ■□□□□□□□□□
But if I have transparent mode switches? Do I have to manually change the VTP Version to 2 to make it forward VTP Updates? Or VTP Version 1 would do?
-
Optionspham0329
Member Posts: 556
Think about that question for a bit...I'm sure you'll figure it out!