Options
Airmagnet question
thehourman
Member Posts: 723
in Off-Topic
What is the purpose of the switching the signal strength to Signal Strength (2nd AP) and the (3rd AP) after merging let's say three access points in a passive survey?What does it mean 2nd (3rd) AP?Am I looking at the 2nd or 3rd AP when I switched the signal strength? I know that I'm looking for grey spots, but what is the difference between Signal strenghth 1st, 2nd and 3rd AP?I was told that if I Switch to Signal Strength (2nd AP), I should see at least two AP. It does not make any sense because even on Signal Strength (1st AP), I can see two or more APs.This is very confusing.
Studying:
Working on CCNA: Security. Start date: 12.28.10
Microsoft 70-640 - on hold (This is not taking me anywhere. I started this in October, and it is December now, I am still on page 221. WTH!)
Reading:
Network Warrior - Currently at Part II
Reading IPv6 Essentials 2nd Edition - on hold
Working on CCNA: Security. Start date: 12.28.10
Microsoft 70-640 - on hold (This is not taking me anywhere. I started this in October, and it is December now, I am still on page 221. WTH!)
Reading:
Network Warrior - Currently at Part II
Reading IPv6 Essentials 2nd Edition - on hold